Creality Ender 3 S1

Direct Extrusion

A direct extrusion system allows us to have much greater control over our filament, making it much easier to print complex filaments such as TPU or flexible filaments. The double gear system provides us with more than 80 Newtons of thrust force. Its compact size means that the whole set weighs 210g, allowing you to achieve printing speeds typical of an extrusion machine Bowden

CR-Touch leveling

Version of Creality of the well-known BL-Touch with a fully automatic adjustment at 16 different points of the printer, which will help to obtain a much smoother first layer.

Dual Z-Axis

To avoid falling or inaccuracy on the non-motorized side, this printer incorporates a double motor (one on each side) to ensure more accurate Z-axis climbing.

Magnetic Strapping

An essential in our printer as it will make it much easier to peel off the parts once printed, as well as a much easier replacement once the surface is deteriorated by use

32-bit motherboard Silent

With a 32-bit board we ensure that we can incorporate the new functionalities of future firmware, by incorporating silent drivers the noise of the printer decreases enormously

Filament sensor

A must if we want to be sure that the end of our spool or a filament break does not spoil our print

Continuation in case of power outage

In case you suffer a power outage, the printer will continue at the point where it left the print, it must be taken into account that in certain parts if the power cut is prolonged the cooling of the bed can cause the movement of the piece making it impossible to resume

4.3-inch screen

Large 4.3" full-color display (non-touch)

Belt tensioners

The tensioners will allow you a much simpler and more precise adjustment of the straps of the X and Y axes

Laser or Light Interface Led

The printer is prepared for light incorporation led or the laser module of Creality (must be purchased separately)

Easy assembly

Assembly in just 6 steps (estimated time 30 minutes)

Technical Specifications

• Printing technology: FDM.
• Print size: 220 x 220 x 270mm.
• Supported Filaments: PLA, TPU, PETG.
• Maximum printing speed 150mm/s.
• Printing accuracy: 0.1mm.
• Compatible filament diameter: 1.75mm.
• Direct extrusion of double gear.
• Automatic leveling via CR-Touch.
• 4.1" color display
• Maximum extruder temperature: 260oC.
• Maximum bed temperature: 100oC.
• 32-bit silent board with 2208 drivers.