Reference: 8430095616954
Brand: Nazza
Isopropyl alcohol, also known as 2-propanol or isopropanol, is used as a cleaner for electrical contacts. -Does not le
Reference: 572-1205
Nozzles (nozzle) for 3D printer, valid for most printers and materials on the market. See in the description the opti
Reference: CAPPTFETL
Brand: Capricorn
This item is sold in units of 10 cm, you can adjust the desired length, adding as many units as you want. We will supply the tube to you continuously for lengths less than 2 m. (for example if you add 5 units we will send you a continuous tube of 50 cm) High quality Teflon tube, with very low friction and high temperature resistance. Capricorn XS vs TL...
Reference: REF000081R
This item is sold in 10cm units, you can adjust the desired length, adding as many units as you want. We will supply you with the tube continuously for lengths less than 2m. (for example, if you add 5 units we will send you a continuous tube of 50cm) Generic Teflon Tube Inner Diameter (ID): 1.9mm ± 0.15mm Outer Diameter (OD): 4.0mm
Reference: 8411322235803
Brand: 3dlac
3DLAC SPRAY 400ml - STRONG AND LONG-LASTING ADHESION - EXTENDED DURABILITY (APPROX. 400 APPLICATIONS) - NO WARPING Its function is to maintain the first layer of plastic to maintain the start of printing constantly, avoiding undesirable errors. 3DLAC is the perfect replacement for Kapton tape and otros types of fasteners due to its cost savings and easy...
Banner
Titan clonic extruder, with its 3:1 gear ratio, provides greater traction torque of the filament at equal motor power.
The filament path is fully guided throughout the body of the extruder and the housing maintains tight tolerances to the drive gears, mitigating the possibilities of filament jamming when the hotend experiences increased backpressure or highly flexible filaments are used.
The tensioner allows the user to adjust the pressure exerted by the drive gears on the filament. This gives you the ability to adjust according to your preferences and to optimize the type of material you are using.
VERSION 3 SCREWS (with solid push wheel)
No review at the moment
Titan clonic extruder, with its 3:1 gear ratio, provides greater traction torque of the filament at equal motor power.
The filament path is fully guided throughout the body of the extruder and the housing maintains tight tolerances to the drive gears, mitigating the possibilities of filament jamming when the hotend experiences increased backpressure or highly flexible filaments are used.
The tensioner allows the user to adjust the pressure exerted by the drive gears on the filament. This gives you the ability to adjust according to your preferences and to optimize the type of material you are using.
VERSION 3 SCREWS (with solid push wheel)
