- Out of stock

Reference: 8430095626656
Brand: Nazza
Isopropyl alcohol, also known as 2-propanol or isopropanol, is used as a cleaner for electrical contacts. -Does not leave residues -purity >99.5% isopropyl alcohol. It is NOT a dissolution -Slightly soluble in water Useful for cleaning the printing bed, as well as for cleaning the remaining resin on printed parts without a trace of stains.
Reference: 572-1205
Nozzles (nozzle) for 3D printer, valid for most printers and materials on the market. See in the description the options to select
Reference: CAPPTFETL
Brand: Capricorn
This item is sold in units of 10 cm, you can adjust the desired length, adding as many units as you want. We will supply the tube to you continuously for lengths less than 2 m. (for example if you add 5 units we will send you a continuous tube of 50 cm) High quality Teflon tube, with very low friction and high temperature resistance. Capricorn XS vs TL...
Reference: REF000081R
Generic Teflon tube Inner diameter (ID): 1.9mm ± 0.15mm Outer diameter (OD): 4.0mm You can adjust the desired length, adding as many 10cm units as you want. We will supply the tube continuously for lengths less than 2m.
Reference: ARTD013
Brand: Artillery 3D
Original Temperature Sensor (Thermistor) for Artillery X1/Genius/X2/Genius Pro Connector-xh2.54,length 80mm, head diameter 3mm Photo shown for illustrative purposes, the product may not correspond exactly as Artillery supplies sensors that, although they are all compatible, are not aesthetically the same.
Banner
Rear Stabilizer Bar Kit for artillery X1
With this kit you will be able to give your printer chassis additional rigidity, which will result in a higher quality of your prints, especially on pieces with a certain height.
*In addition to the assembly of the kit, we recommend, whenever possible, placing the filament coil outside the original support placed on the top to avoid increasing oscillations of the Z axis.
*Including screws, 3D printed parts and bars
Rear Stabilizer Bar Kit for artillery X1
With this kit you will be able to give your printer chassis additional rigidity, which will result in a higher quality of your prints, especially on pieces with a certain height.
*In addition to the assembly of the kit, we recommend, whenever possible, placing the filament coil outside the original support placed on the top to avoid increasing oscillations of the Z axis.
*Including screws, 3D printed parts and bars