- Out of stock

Reference: 8430095616954
Brand: Nazza
Isopropyl alcohol, also known as 2-propanol or isopropanol, is used as a cleaner for electrical contacts. -Does not le
Reference: 572-1205
Nozzles (nozzle) for 3D printer, valid for most printers and materials on the market. See in the description the opti
Reference: CAPPTFETL
Brand: Capricorn
This item is sold in units of 10 cm, you can adjust the desired length, adding as many units as you want. We will supply the tube to you continuously for lengths less than 2 m. (for example if you add 5 units we will send you a continuous tube of 50 cm) High quality Teflon tube, with very low friction and high temperature resistance. Capricorn XS vs TL...
Reference: REF000081R
This item is sold in 10cm units, you can adjust the desired length, adding as many units as you want. We will supply you with the tube continuously for lengths less than 2m. (for example, if you add 5 units we will send you a continuous tube of 50cm) Generic Teflon Tube Inner Diameter (ID): 1.9mm ± 0.15mm Outer Diameter (OD): 4.0mm
Reference: 8411322235803
Brand: 3dlac
3DLAC SPRAY 400ml - STRONG AND LONG-LASTING ADHESION - EXTENDED DURABILITY (APPROX. 400 APPLICATIONS) - NO WARPING Its function is to maintain the first layer of plastic to maintain the start of printing constantly, avoiding undesirable errors. 3DLAC is the perfect replacement for Kapton tape and otros types of fasteners due to its cost savings and easy...
Banner
The surface Ultrabase It is made up of small micropores that once heated provide additional grip to the piece, once cooled the piece loses that additional grip being easier to peel off. With a heated base of this type, the need for additional adhesion methods such as lacquer, glues, etc., is very rare.
This type of base is becoming more and more common, being used by brands such as Anycubic, Artillery, Geeetechetc.
Warning: Once the printing is finished, you must wait for the bed to cool down to proceed with the removal of the part, trying to peel off the part while the bed is still hot can cause the breakage of the microporous surface layer
The surface Ultrabase It is made up of small micropores that once heated provide additional grip to the piece, once cooled the piece loses that additional grip being easier to peel off. With a heated base of this type, the need for additional adhesion methods such as lacquer, glues, etc., is very rare.
This type of base is becoming more and more common, being used by brands such as Anycubic, Artillery, Geeetechetc.
Warning: Once the printing is finished, you must wait for the bed to cool down to proceed with the removal of the part, trying to peel off the part while the bed is still hot can cause the breakage of the microporous surface layer