Direct Metal Extruder
A direct extrusion system allows us to have much greater control over our filament, making it much easier to print complex filaments such as TPU or flexible filaments. The double gear system provides us with more than 80 Newtons of thrust force. Its compact size makes the whole set weigh 344g. The incorporation of a barrel All Metal and a metal arm allows us to print at temperatures above 230o (<290o) without any problems
CR-Touch leveling
Version of Creality of the well-known BL-Touch with a fully automatic adjustment at 16 different points of the printer, which will help to obtain a much smoother first layer.
Dual Z-Axis
To avoid falling or inaccuracy on the non-motorized side, this printer incorporates a double motor (one on each side) to ensure more accurate Z-axis climbing.
Magnetic Metal Strapping
An essential in our printer as it will greatly facilitate the peeling off of the parts once printed, as well as a much easier replacement once the surface is deteriorated by use. A metal strap provides greater durability than a plastic one
32-bit motherboard Silent
With a 32-bit board we ensure that we can incorporate the new functionalities of future firmware, by incorporating silent drivers the noise of the printer decreases enormously
Filament sensor
A must if we want to be sure that the end of our spool or a filament break does not spoil our print
Continuation in case of power outage
In case you suffer a power outage, the printer will continue at the point where it left the print, it must be taken into account that in certain parts if the power cut is prolonged the cooling of the bed can cause the movement of the piece making it impossible to resume
4.3-inch touchscreen
Large 4.3" full color touch screen. You should be aware that touch screens often have trouble using the color change functionality.
Belt tensioners
The tensioners will allow you a much simpler and more precise adjustment of the straps of the X and Y axes
Light Led
To facilitate the visualization of the piece, a light is incorporated led
Interface for Laser
The printer is prepared for the incorporation of the laser module of Creality (must be purchased separately)
Easy assembly
Assembly in just 6 steps (estimated time 30 minutes)
Technical Specifications
- Printing technology: FDM.
- Print size: 220 x 220 x 270mm.
- Supported Filaments: PLA, TPU, PETG.
- Maximum printing speed 150mm/s.
- Printing accuracy: 0.1mm.
- Compatible filament diameter: 1.75mm.
- Direct extrusion of double gear.
- Automatic leveling via CR-Touch.
- 4.1" color display
- Maximum extruder temperature: 300oC.
- Maximum bed temperature: 110oC.
- 32-bit silent board with 2208 drivers.
No review at the moment
