Direct Extrusion
A direct extrusion system allows us to have much greater control over our filament, making it much easier to print complex filaments such as TPU or flexible filaments. The double gear system provides us with more than 80 Newtons of thrust force. Its compact size makes the whole set weigh 210g, allowing you to achieve printing speeds typical of a machine with Bowden extrusion
CR-Touch leveling
Creality's version of the well-known BL-Touch with a fully automatic adjustment at 16 different points of the printer, which will help to obtain a much smoother first layer.
Dual Z-Axis
To avoid falling or inaccuracy on the non-motorized side, this printer incorporates a double motor (one on each side) to ensure more accurate Z-axis climbing.
Magnetic Strapping
An essential in our printer as it will make it much easier to peel off the parts once printed, as well as a much easier replacement once the surface is deteriorated by use
32-bit motherboard Silent
With a 32-bit board we ensure that we can incorporate the new functionalities of future firmware, by incorporating silent drivers the noise of the printer decreases enormously
Filament sensor
A must if we want to be sure that the end of our spool or a filament break does not spoil our print
Continuation in case of power outage
In case you suffer a power outage, the printer will continue at the point where it left the print, it must be taken into account that in certain parts if the power cut is prolonged the cooling of the bed can cause the movement of the piece making it impossible to resume
4.3-inch screen
Large 4.3" full-color display (non-touch)
Belt tensioners
The tensioners will allow you a much simpler and more precise adjustment of the straps of the X and Y axes
Interface for Laser or Led light
The printer comes prepared for the incorporation of LED light or the Creality laser module (must be purchased separately)
Easy assembly
Assembly in just 6 steps (estimated time 30 minutes)
Technical Specifications
- Printing technology: FDM.
- Print size: 300x 300 x 300mm.
- Supported filaments: PLA, TPU, PETG.
- Maximum printing speed 150mm/s.
- Printing accuracy: 0.1mm.
- Compatible filament diameter: 1.75mm.
- Direct extrusion of double gear.
- Automatic leveling via CR-Touch.
- 4.1" color display
- Maximum extruder temperature: 260oC.
- Maximum bed temperature: 100oC.
- 32-bit silent board with 2208 drivers.
No review at the moment
