HOW TO USE
1 REMOVE THE SEAL FROM THE CONTAINER Once the container is received, it is necessary to remove the internal seal that prevents the contents from spilling before use, for this it is necessary to unscrew the applicator cap and remove the internal seal.
2 APPLY THE PRODUCT Apply the product on the printing base evenly, thereby creating a thin adhesive film that will provide adhesion. Once the product is applied, it is recommended to close the bottle again so that the inner liquid does not dry out causing the nozzle to clog.
3 PRINTING THE SMART PART Stick is a product that works both in printers with hot bed and without it, in the case of printers with hot bed, the ideal operating temperature is 70-90 oC. In prints where a high adhesion is required, it is recommended to increase the temperature of the base between 90-100oC for the first layer in order to achieve a high adhesion between the material and the adhesive and then reduce that temperature to 70 oC so that the structural capacity of the adhesive is increased.
4 REMOVAL OF THE PIECE Once the piece is manufactured the union between materials is very strong so it is recommended to introduce the tray in water so that this union is weakened and can be extracted later by using a spatula.
5 CLEANING OF THE PLATFORM. In many cases the layer created once the adherent has been applied can be reused with the same results once the layer is defective and must be replaced, it is necessary to apply hot water to the printing tray so that the adhesive is weakened and subsequently remove by means of a spatula. It is recommended to use the product on a glass base or a removable base so that cleaning can be easily carried out later.
No review at the moment
